The command uses the following structure:
nrfutil mcu-manager ble image-list [<options>] <args>
nrfutil mcu-manager ble parameters [<options>] <args>
nrfutil mcu-manager ble image-upload [<options>] <args>
nrfutil mcu-manager ble image-test [<options>] <args>
nrfutil mcu-manager ble image-confirm [<options>] <args>
nrfutil mcu-manager ble image-erase [<options>] <args>
nrfutil mcu-manager ble reset [<options>] <args>
nrfutil mcu-manager ble bootloader-mode-get [<options>] <args>
nrfutil mcu-manager ble bootloader-name-get [<options>] <args>
nrfutil mcu-manager ble raw-smp-request [<options>] <args>
| Long | Short | Values | Description |
|---|---|---|---|
--hci-serial-port |
ARG |
Serial port of a Nordic Semiconductor device that exposes the Softdevice Controller over UART using the H:4 HCI transport protocol. This corresponds to the hci_uart Zephyr example in the nRF Connect SDK. This device is used as the Bluetooth LE controller for communicating over Bluetooth LE. |
|
--timeout |
ARG |
Timeout in seconds for the read responses in the transport layer. | |
--hci-dump |
PATH |
Path to the log file where the full HCI packet log will be written. If not specified, no HCI log file will be written. |
|
--help |
-h |
- | Print help (see a summary with '-h'). |