The Blinky Example shows how to configure the GPIO pins as outputs. These outputs can then be used to drive LEDs, as in this example.
When the application starts, some GPIO pins are configured as outputs to drive the LEDs. The application then loops while toggling the state of one of the LEDs every 500 milliseconds.
You can use this example without a SoftDevice. The name of the example is
blinky_blank_
Board
, where
Board
is the supported board. If you are not using the Keil Pack Installer, you can find the source code and project file of the example in the following folder:
<InstallFolder>\examples\peripheral\blinky
Alternatively, you can run it with SoftDevice S110. The name of the example is
blinky_s110_
Board
, where
Board
is the supported board. If you are not using the Keil Pack Installer, you can find the source code and project file of the example in the following folder:
<InstallFolder>\examples\peripheral\blinky
Testing
Test the Blinky Example application by performing the following steps:
- Compile and program the application.
- Observe that the LEDs are blinking.