ANT Continuous Waveform Mode

nRF5 SDK v14.1.0
This example requires the following SoftDevice: S212

Important: Before you run this example, make sure to program the SoftDevice .

The ANT CW Mode example is designed to show how to initialize the continuous waveform mode for certification testing using the ANT SoftDevice.

This example can be used with a single module in RF testing.



Page-1 Sheet.790 Donut Donut.261 Donut.262 Rectangle.18 Rectangle.266 Rectangle.267 Rectangle.268 Rectangle.269 Rectangle.270 s.247 Node A Node A Sheet.248 Sheet.249
Continuous waveform mode broadcast


Setup

You can find the source code and the project file of the example in the following folder: <InstallFolder>\examples\ant\ant_cw_mode

Testing

Note: You can use a custom channel or encryption when running any of the ANT examples. When adding a new channel or encryption, remember to update ANT stack configuration .

  1. Compile and program the Continuous Waveform Mode application onto the module.
  2. This will run a modulated waveform at 2410MHz and +4dBm output power for doing wireless certification testing. You will require proper equipment for the testing, such as spectrum analyzers and anechoic chambers.