New and inherited anomalies

nRF54L15 Revision 2 Errata

The following anomalies are present in Revision 2 of the nRF54L15 SoC.

Table 1. New and inherited anomalies
ID Module Description Inherited from Revision 1
1 CCM MAC error is returned if MDATA size is slightly larger than MLEN X
6 RADIO Spectrum of transmitted signal is not optimal for 802.15.4 X
7 UARTE RXD.AMOUNT is not updated after RXFLUSH if FIFO is empty X
8 SPIM Wrong data is transmitted on MOSI X
10 SPU PERM and FEATURE registers cannot be locked X
13 KMU Provision task is not ignored when KMU is busy X
16 VPR Cleared EVENTS are triggered again on the next CNT0 event X
17 VPR Bus faults during hibernate save sequence are ignored X
18 VPR Subsequent VPR hibernate sleeps might fail to save ra X
20 CLOCK RADIO payload is not transmitted X
21 SPIM MOSI line toggles after transmission ends X
22 TIMER EVENTS_COMPARE[n] event is not generated X
23 RRAMC READY and READYNEXT events are generated when CPU wakes up X
24 TIMER EVENT_COMPARE is not generated when using PPI X
25 TIMER EVENT_COMPARE[n] is not generated X
26 DPPI PPIB between domains uses wrong security attribution X
30 CLOCK, GRTC GRTC operates incorrectly at low temperature X
37 POWER Current consumption might increase after pin reset or power cycle X
39 CLOCK Device can behave erratically after XOSTART X
41 RADIO Sensitivity is degraded on n*32 MHz channels X
44 EASYDMA DMA.RX.AMOUNT is not updated with bytes count after match event X
47 POWER Device resets while debugging in System OFF mode X
48 RESET RESETREAS register might show an additional wakeup source after reset X
49 RADIO First bits of on-air packet are not correct X
50 RRAMC SPU00 incorrectly reports that RRAMC has DMA X
54 SPIS SDO is configured as an input when SPIS is idle X
58 COMP Static 300 µA current after COMP has been enabled X
59 EGU EGU uses incorrect security attribution X
63 RESET Soft reset might not fully reset the device X
100 GPIO Pins with analog functionality might be shorted together during power-on reset X
102 CCM Operation fails when CCM MAC length is set to 0 X
103 GPIO State is inconsistent during power-on reset X
105 TWIM Peripheral becomes unresponsive when disabled during clock stretching X
111 SAADC Output data is incorrect when noise shaping is used X
114 GPIO Current consumption increases when Wake on pin is used X