Configure the board for QSPI connection

nRF7002 Expansion Board II Hardware

If the application requires Quad Serial Peripheral Interface (QSPI) connection, some hardware modifications are required to route the QSPI signals to the correct location on the expansion header.

The following steps describe how to strap the QSPI connection.

  1. Cut straps SB1–SB4 that connect the signal to the SPI.
  2. Solder solder bridges SB5–SB8 to connect the signals to the QSPI.
Figure 1. nRF7002 EBII solder and cut-straps for QSPI
EK solder and cut-straps for QSPI