When the debugger receives a Data Terminal Ready (DTR) signal from a terminal, it performs automatic Hardware Flow Control (HWFC) detection.
HWFC detection
Automatic HWFC detection is done by driving Clear to Send (CTS) from the debugger and evaluating the state of Request to Send (RTS) when data is first sent or received. If the state of RTS is high, it is assumed HWFC is not in use. If HWFC is not detected, pins P0.03/P1.07 (CTS) and P0.02/P1.06 (RTS) are free for the nRF application to use.
After a power-on reset of the debugger, all UART lines are tri-stated when no terminal is connected to the virtual serial port. If HWFC has been used and detected, P0.03/P1.07 (CTS) is driven by the debugger until a power-on reset has been performed or until a new DTR signal is received and the detection is redone.
The debugger has a pull-down 100 kΩ resistor connected from CTS to ground.