Set command

The modem must be deactivated before the command can be used.

Syntax:

%SKYLO=<feature_id>,<state>

The set command parameters and their defined values are the following:

<feature_id>

Integer. Skylo operational mode and features.

0 – Configures generic Skylo features. This setting is activated automatically when a Skylo UICC is detected from IMSI. The %XOPCONF=21 command can be used to activate this configuration.

1 – Mobile-originated device. Optimization enables a power saving for devices that only initiate communication. The modem optimizes tracking area updates to reduce current consumption.

2 – SMS requirements. Enables Skylo-specific requirements for SMS functionality.

3 – Signal quality check. Enables a check to verify that the signal quality is sufficient before the modem reattempts Attach. This feature prevents futile connection attempts in poor signal conditions, which helps save power and reduce unnecessary network signaling. This can also be configured with the %FEACONF command's <feature_id> value 7.

<state>

Integer. Enables or disables the feature.

0 – Feature is disabled.

1 – Feature is enabled.

The following command example enables generic Skylo requirements:

AT%SKYLO=0,1
OK