Setting up LitePoint IQxel-M tester

nRF5x OTA Testing with LitePoint Bluetooth® Advanced

This section will guide you through connecting the LitePoint IQxel-M tester to power and Ethernet and finding the IP address of the LitePoint IQxel-M tester.

Complete the following steps to set up the IQxel-M tester:

  1. On the back panel of the LitePoint IQxel-M tester, connect the power cable, an Ethernet cable, and a VGA cable to a monitor.
    Power and Ethernet connectors
  2. On the front panel of the LitePoint IQxel-M tester, connect one end of the RF coax to the RF1 connector and the other end to the RF enclosure.
    Connecting RF coax
  3. To power up the LitePoint IQxel-M tester, press the power button on the front panel.
    The monitor connected to the LitePoint IQxel-M tester now displays the LitePoint Monitor:
    LitePoint Monitor
  4. Take note of the IP address as you will need it in Performing LitePoint Bluetooth Advanced test.