Important: Before you run this example, make sure to install the SoftDevice .
Basic examples to test ANT connectivity between Master and Slave.
They both use public network key {0, 0, 0 , 0 , 0, 0, 0}
ANT Broadcast TX
The channel period is set to 4 Hz (8192). When a packet is transmitted, it will indicate the state BSP_INDICATE_SENT_OK . Whenever the processor enters sleep state, the state BSP_INDICATE_ALERT_0 ist set. The BSP_INDICATE_ALERT_OFF state is set when woken up by (any / RF ) interrupt.
The name of the example is
ant_broadcast_tx_s210_pca10028
. If you are not using the Keil Pack Installer, you can find the source code and project file of the example in the following folder:
<InstallFolder>\examples\ant\ant_broadcast\broadcast_tx
ANT Broadcast RX
The example uses wildcard connection, which implies that it will connect to the nearest ANT device that is broadcasting. The channel period is set to 4 Hz (8192). When a packet is received, it will indicate the state BSP_INDICATE_RCV_OK . Whenever the processor enters sleep state, the state BSP_INDICATE_ALERT_0 ist set. The BSP_INDICATE_ALERT_OFF state is set when woken up by (any / RF ) interrupt.
The name of the example is
ant_broadcast_rx_s210_pca10028
. If you are not using the Keil Pack Installer, you can find the source code and project file of the example in the following folder:
<InstallFolder>\examples\ant\ant_broadcast\broadcast_rx