nRF54LM20B Engineering B Errata

nRF54LM20B Engineering B Errata
Revision history
New and inherited anomalies
[7] UARTE: RXD.AMOUNT is not updated after RXFLUSH if FIFO is empty
[8] SPIM: Wrong data is transmitted on MOSI
[20] CLOCK: RADIO payload is not transmitted
[26] DPPI: PPIB between domains uses wrong security attribution
[30] CLOCK, GRTC: GRTC operates incorrectly at low temperature
[37] POWER: Current consumption might increase after pin reset or power cycle
[39] CLOCK: Device can behave erratically after XOSTART
[44] EASYDMA: DMA.RX.AMOUNT is not updated with bytes count after match event
[47] POWER: Device resets while debugging in System OFF mode
[49] RADIO: First bits of on-air packet are not correct
[50] RRAMC: SPU00 incorrectly reports that RRAMC has DMA
[54] SPIS: SDO is configured as an input when SPIS is idle
[59] EGU: EGU uses incorrect security attribution
[63] RESET: Soft reset might not fully reset the device
[69] SPIM: STOPPED event might not be generated in suspend state
[102] CCM: Operation fails when CCM MAC length is set to 0
[104] GPIO: Pins with analog functionality might be shorted together during power-on reset
[105] TWIM: Peripheral becomes unresponsive when disabled during clock stretching
[111] SAADC: Output data is incorrect when noise shaping is used
[114] GPIO: Current consumption increases when Wake on pin is used

Back to home page